CPP cast film line 1.750 mm width

 

GROUNDFLOOR

 A, B, C, D, E = EXTRUDERS

1 GENERAL PANEL of DISTRIBUTION 700 KW

2 SUPERVISOR MACO 20 KW

3 MEASUREX 5 KW

5 CUTTING SYSTEM of EDGE TRIM 40 KW

6 ROLL SHAFT EXTRACTOR 10 KW

 

10.5 m

1^st FLOOR

8 INDIVIDUAL VACUUM RESIN LOADER

9 THERMOREGULATION PANEL 200 KW

10 LINE and EXTRUDERS PANEL 340 KW

11 WINDING PANEL 10 KW

12 HEAT EXCHANGER

·      COOLING SYSTEM IS A CLOSED CYCLE BY A HEATER EXCHANGER (n° 12), WHICH NEEDS A FREEZING FLUID (WATER) ABLE TO A EXCHANGE 400.000 FRIGORIE. A CHILLER AIR SYSTEM WITH A COMPRESSOR OF 100 KW CAN BE USED. IT CAN BE PUT ON ANOTHER POSITION.

·      ELECTRICAL ENERGY DISTRIBUTION TO ALL THE PLANT START FROM THE GENERAL PANEL THAT MUST BE SUPPLIED BY A 600 KW TRANSFORMER

 

CAST E DATA SHEET

Builder : OMAM

Year of building 1993

 

Production: 450 Kg/h

Thickness: 12/50 my

Line Speed: 240 m/min 40 KW

Width: 1750 mm

Extruders:

Num.	Diam.	Length	Motor KW
3	70	~ 1/28	79 each
2	60	~ 1/28	42.5 each

 

Supervisor: Maco

Thickness check: Measurex 2040 5 KW

Measuring: Volumetric Pump extrex at the top of extruders controlled by the supervisor

Filter excenger: Db-plast hydraulic

Die: Extrusion-Die 1950 mm

Feed-block: Cloeren a 5 vie + distributor with inversion layers

Thermoregulation: Video by supervisor 20 KW + 200 KW

Chill-Roll: 2200 mm

Alignment: Eltex

Transversal Oscillator: Erhardt+Leimer

Winding: DOLCI winder completed by the roll

transport cart, winding axle and by contact

Shaft: n.3 steel diam. 76 mm

n.3 Aluminium diam. 112 mm

n.3 Aluminium diam. 152 mm

Recycling edge trim: Croci

Roll shaft extractor: PONTI, automatic roll shaft extractor and

Automatic shaft re-feeding system